operator-adjusting-rewinding-tension

Why Does Laminated Film Curl After Rewinding?

Laminated film may look flat immediately after lamination but develop edge curl, cross-direction bending, or roll deformation after rewinding. In most cases, laminated film curl after rewinding is caused by uneven internal stress, which can result from winding tension, differences in substrate properties, adhesive distribution, or dimensional changes during curing and storage. For flexible packaging converters,…

Solventless Lamination films

Best Films for Solventless Lamination: A Complete Material Selection Guide

Unlike solvent or water-based conventional lamination processes that require drying tunnels to evaporate the carriers, solventless lamination employs 100% solid two-component polyurethane adhesives. Consequently, different materials impose very different requirements on adhesive chemistry, web tension control and mechanical press design. The removal of lamination flaws like tunnelling, curling, channelling and delamination is tied to the knowledge of surface…

End of content

End of content